霍利威尔 MX7 如何设置扫码后自动回车换行 设置方法如下： ‘开始’ ‘设置’ ‘控制面板’ ‘Barcode’ 里面设置参考下面文档 How to program a Carriage Return on a Supply Chain device Applies To MX3X, MX3H (MX3Plus), MX5, MX5X, MX5I, MX6, MX7, MX7CS, MX7T (Tecton), MX7L (Tecton CS), MX8, FC300, MX9, MX9CS, MX9HL VM1 Thor, VX3X, VX3H (VX3Plus), VX5, VX6, VX7, VX8 Karv, VX9 Forj HX2, HX3 Pocket PC 2002, Windows Mobile 2003, Windows Mobile 6, Windows Mobile 6.5, Windows CE 4.2, Windows CE 5, Windows CE 6, Windows Embedded Standard 2009, Windows XP, Windows 7 RFTerm Question/Problem How to program a Carriage Return on a Supply Chain device? How to program an automatic 'Enter' after each read bar code on a Supply Chain device? Resolution In the Wedge software on Windows CE and Windows Mobile devices: Go to 'Start' > 'Settings' > 'Control Panel' For Windows Mobile: 'Start' > 'Settings' > 'System'. Click on 'Data Collection' or 'Scanner'. Click on the 'Barcode' or 'Data Options' tab. Click on 'SymbologySettings'. Check the 'Add' box. Enter ' ' without quotes into the 'Suffix' box. ^M Click OK to confirm and exit all windows. In RFTerm on any device: Click on 'Session' > 'Configure' or press 'control, Shift, N'. Scroll to the 'Barcode' tab. In the 'Barcode Postamble' box, type ' ' (without the quotes). ^M Click OK to confirm. Reboot the terminal make the change active. 本文来源：https://www.wddqw.com/doc/e327056f306c1eb91a37f111f18583d049640fd3.html